Whirlpool Water Heater Lighting Instructions

Tank type gas water heaters use a pilot light to ignite the gas burner when the water in the tank needs to be heated.

Whirlpool water heater lighting instructions.

How to light a water heater. It s free for you to use and amazon pays a small commission https amzn to 33i9exy in this vid. Keep the knob pushed in while repeatedly clicking the spark igniter button. This water heater must be installed according to all local and state codes or in the absence of local and state codes.

Use my amazon link to shop. Download free electronic versions of our whirlpool water heater care use and installation instructions. If you don t have any hot water the first thing you should do is check to see if the pilot light on your rheem water heater has gone out. This water heater is design certified by csa international as a category i non direct vented water heater which takes its combustion air either from the installation area or from air ducted to the unit from the outside.

In most cases you can relight a pilot. Make sure the gas supply valve is turned on. If the status light is not flashing try lighting the pilot using the instructions on the water heater s label. If you live in a home with a gas water heater and notice cold water coming from your hot water faucet there s a good chance your pilot light has gone out.

Usually the first warning. How to light the pilot for a gas hot water heater. When lighting the pilot make sure the knob on the gas control valve is fully pushed in.